RS232 max232 interface & 3.0volt at "M" pin ?

nielsht

New member
I did made the RS232 interface for interfaceing my from 1995 car from this page :
(but with external power supply from cigarette lighter socket)

http://www.techedge.com.au/vehicle/aldl8192/8192hw.htm

But when i connect the interface to the PC (not connected to ALDL yet! just want to first measure things at the "M" wire which is supposed to go the to DATA line on the ADLD connector vehicle) i measure only around 3.0V at that wire (without starting a datalog software) and when i start e.g. freescan i measure around 2.7V.
At pin 11 directly i measure the 5.0V but not anymore after it passed the diode.
Shouldn't that wire measure only 5.0V or 0.0V (logical 1 and logical 0) i though the max232 only make 5V or 0V to that interfacing pin?
I do measure 5Volt after the 7805 regulator so that's ok and i measure around 5.0Volt at pin 12 before it reaches the diode.Is anything wrong ?
Thanks in advance & pardon my bad english (i am dutch)
 
Last edited:
Top