Running lean on pass bank?

just a 6

R.I.P MyClone
I'm curious if our stock Sy/Ty's are running leaner on passenger side bank compare to driver bank? The reason i'm asking is because when i rebuilt my engine all 3 rods on pass side were bent. And now when i'm rebuilding another Sy engine, found all 3 piston on pass side have cracked ringlands? Anybody else notice any problem with pass side running lean or something?
 

jwaller

Evil Genius/SyTy Guru
typically it's #1 and #6 that run lean. but I've busted 2 syty blocks in the #4 hole. so that leads me to belive it is the pass side.

but then again there could be 100 variables making this the case.
 

MikeRenz

not stock
I've always wondered about the fast that the turbo is so much closer to the pass side than the drivers side. I really think the pass side is gonna work harder than the drivers side. Same concept as equal length headers I guess.
 

Methuselah

New member
I dont have much experience but the #6 piston in the Typhoon engine I tore down had broken ring lands, adding a smidgen of weight to the argument.
________
TEEN VID
 
Last edited:

TurboTony

Active member
Mine had broken lands on #1 and 5, shrug.

Deans Sy broke the #4 rod.

Still haven't looked at my Ty to see which one let go.

Tony
 

leroy

Donating Member
If the ecm wiring diagram is correct, there are separate injector drivers for right and left bank. The failure of one driver may cause one side to go lean. The worst part is you could rebuild and do the same thing again.

Jim
 
Top