Running like crap....still!!

BoostedSUV

Active member
I am going to try this one more time before I burn my TY to the ground and collect the insurance! (joking insurance companies) For three months now I have not been able to get my truck running right. It has no power, breaks up, pops, etc. It makes so little power it will only make 10lbs of boost on the autometer gauge (reads 2lbs on factory gauge???) I have changed map sensor, ignition module, O2 sensor, and used 2 different Ultimate chips programed for the combination. Since I installed a built motor, pte 60 turbo, 50# injectors, and 3 bar map i have been strugling with this P.O.S. and nobody knows anything about them! Air/fuel reads super lean while it's popping and it jumps to rich and clears right up. Its accelerates better at half throttle than WOT. Everything worked fine when completely stock. PLEASE HELP ME!!



Truck actually runs better (not great) with only stock chip plugged in and 50#ers and 3 bar.... makes no sense!
 

BoostedSUV

Active member
Re: Running like crap....still!!

Yeha, that was the obvious check. It's set at 0deg with bypass unplugged. I even checked it with 2 seperate timing lights to be sure.
 

Don W.

Stab it and steer it
Re: Running like crap....still!!

Since you say it "jumps" from running lean, and poorly, to rich and ok, I think I'd be looking for a bad connection somewhere. A Weather Pac connector that has one of its pins or receptacles out of place. Another thought; have you tried a completely different ECM? Also TPS comes to mind. With a 3 bar MAP the factory boost gauge is worthless so forget that.

Let me ask some questions.
Does it rev in neutral OK?
When you power brake it does run good or bad?
If it goes bad with power braking then at what point, meaning boost and RPM, does it go bad? For example, does it go bat at the point where boost just begins or at some higher number, say 5lbs?
 

BoostedSUV

Active member
Re: Running like crap....still!!

I haven't changed the TPS yet but I have been considering that, and I don't have another ECU to try. I am glad you mentioned that the factory boost gauge wont work with a three bar cuz that makes me feel a little better.



As far as power breaking it... it's real bad. i can almost put it to the floor and not push the breaks. It feels like it stumbles right as it starts to make boost. It revs in nuetral just fine though. Nice and responsive
 

Don W.

Stab it and steer it
Re: Running like crap....still!!

Based on your descriptions I'd be very suspicious of ignition. Just FYI when I installed my MSD coil it did just what you're describing. (Coil was bad but that's another story.) My point is that as soon as the engine comes under load, power breaking or just trying to accelerate, even on a normally aspirated engine, cylinder pressures go up considerably hence the demand on the ignition system goes up tremendously. So, especially with your build, cap, rotor, wires (separated and away from places that they can short to), properly gaped plugs (what plugs and gap are you running anyway?) good coil (lot of people seem to think the stock works well) IMHO timing would not be a direct cause of these problems and you say you've checked that anyway. So there you have it. I think it's ignition. If you think all the above is good then try a new coil.

I guess you call all that a :2cents: :rant: :)
 

BoostedSUV

Active member
Re: Running like crap....still!!

hmmm... The MSD coil did work before on the stock motor, but I have the stock coil still and it would be easy enough to change real quick. i think the plugs were gapped at .035. I have new NGK UR5's plugs for it that I am putting in this weekend anyway. Everything is new, that's what is driving me crazy! I have spent hundreds in new parts to figure this thing out.
 

Don W.

Stab it and steer it
Re: Running like crap....still!!

Hummm, .035. Might be a bit much. Just for the heck of it bring 'em back to .028. But don't do the coil and the plugs at the same time. That way, if one fixes it, you'll know which one it was.
 

berzerker

wookie
Re: Running like crap....still!!

i've noted this suggestion before in many posts. and here it goes agian. start with an cold engine . start it and let it run for 30 seconds. shut engine off . then take spray bottle with water and spray it directly onto exhaust manifold port for each cylinders. if all off the water sizzles and evaps. quickly or not you'll be able to tell if you have an dead or weak cylinder issue. then you'll be able to judge out sensor or ignition ,or internal problems.because one dead cylinder will tell you that a sensor is not the problem
 

BoostedSUV

Active member
Re: Running like crap....still!!

I don't have another ECU and this worked fine before hand. I am so aggrevated with spending money on this thing trying to fix a problem i Can't find. I have an infared temp gun, I will try each cylinder.

The only other thing I forgot to menion was that when I start the truck cold it runs worlds better. As soon it warms up it get worse.

I will change plugs and coil this weekend and see if that fixes it for now..
 

Don W.

Stab it and steer it
Re: Running like crap....still!!

BoostedSUV said:
The only other thing I forgot to menion was that when I start the truck cold it runs worlds better. As soon it warms up it get worse.

OK, let me ask this; can you build boost when it's cold? (I personally don't condone this on a cold motor but a one time test would help here.) If you -can- build boost when cold then I'm still thinking ign. Either coil or ign module is breaking down when hot would be two things that I'd change. Be sure to put some heat transfer "grease" under the Ign module.
 

BoostedSUV

Active member
Re: Running like crap....still!!

Has a new ign. module and I swap in the old coil. Still didn't make much change. It will build boost and run smooth cold but not as much when it get's hot. I am going to change plugs this weekend and see if that smooths it out.
 

BoostedSUV

Active member
Re: Running like crap....still!!

its a steady break-up that is pretty consistant with certain RPM'S. Its not like a miss that you would get from a bad plug or wire...
 
Top