Scanmaster 3

johne30m3

Junior Member
Yeah just installed the scanmaster 3 and its nice to know about all thats going on with the engine. I still have to buy a laptop and wideband o2 though . Well first thing I did was re-install my stock chip and switched back to a 2 bar map sensor to do some runs. First let me say that my plugs/wires/cap and rotor are about 6 years old and about 8000 miles, so I'm assuming they should be changed. I do have all the new tune up stuff just haven't installed yet. The other night was cold about 28 degrees so I took the truck out to try the scan tool, I would get about 1.5 - 2 kr momentary down low but was seeing 0 kr up top. I proceeded to do a few more pulls and got a couple kr free runs from about 45-90 mph, I did want to start lower cause my tranny slips in 1st gear. Well today I took out the truck for a ride, temps were in the low 40's and did a couple pulls and was still get a couple degrees of kr down low but would taper up high. I even saw a few knock free pulls, but I would let my iat's come down because they were reaching 105-110 degrees. The other night when it was colder I was seeing about 70-85 degrees iat's .I also noticed my boost was a little higher than usual so I got it down to about 14-15 psi. What would cause 2-3 kr when just blipping the throttle at idle, bad motor mount or just bad ignition parts? Well I guess I will start with the tune up parts and install the used tranny I bought. I just want to get the truck running good before I put in my new turbo/dp/injectors and chip. Sorry for the some what long post.
 

Ross L

Member
Re: Scanmaster 3

good info. I get the same kr if I blip the throttle. I need to call turbotweak though because mine "hangs up" about 50 percent of the time and I have to do a restart to get it working again. The scanmaster is a great tool! sounds like your truck is running good. 0 KR in 3rd is a GOOD thing ;)
 
Top