setting timing

flintdawg

New member
i was wondering.....just finishing up rebuild....when setting my timing where should i start.....top dead center? any help please
 

kwick6

Donating Member
You can have someone hold a pencil in #1, turn slowly clockwise until it stops. Make a mark on the harmonic balancer. Then turn it CCW, till it stops, make another mark.

Half way between your two marks is TDC. Make a good visible mark. With the tan wire unplugged, put a timing light on it. Then turn the distributor cap while engine is running to set it at mark. Its fun to hold the timing light, and turning the dist cap, then trying to tighten the bolt that holds the dist cap in place without loosing your mark.

Have fun
Scott
 

JoeLutz

New member
Scott has a good point. The balancer on my Ty had slipped, so the mark was way off. Did you use a new balancer?
 

kwick6

Donating Member
It is a single tan wire, ~ 16 AWG.
It will have a plastic connector in the middle of the wire that will allow you to pull it apart.
Just look under the passenger side dash, you can't miss it.

Scott
 
Top