simulated nbo2

gjp

another post whore
I am using a wbo2 with a simulated narrow band output. The DM shows my o2 voltages being verry low. In fact they are constant around 430-460mv?? my wbo2 guage shows I am running fine. WOT in the high 10's low 11's . idles at 12-13.??
 

live1053rulz

Nor Cal SyTy
Re: simulated nbo2

isn't wot ideal at 12.9 or something? im still not familiar with mv. the r250 doesn't sense knock does it?
 

gjp

another post whore
Re: simulated nbo2

I e-mailed plx. I was told idle at 12-13 was normal. I see erratic readings sometimes. Not shure why. Not sure if its engine problems or sensor problems. Idle is fine at 800rpm but the sensor bounces from 19.x to 10.x about 10 times a seccond. sometimes its fine though. My ecu was reading 420-460 mv through the whole wot run, at ilde and part throttle.? that was odd. sounds like I might have a bad sensor but I am not sure. it has only been in for 200 miles and has done this since day one.
it has no Kr sensor.
 

Daryl H

Donating Member
Re: simulated nbo2

Double check the grounds on the PLX controller. Make sure it has a separate ground from anything else besides the O2 gauge. mV's are real sensitive to other items that are grounded to it.
 

gjp

another post whore
Re: simulated nbo2

I first had it grounded to the chassis. Thinking it was the ground I ran a ground from the block strait to the unit but I have the boost guage, wbo2 guage and stat guage hooked up to it too. Should i isolate it?? strait to the battery?
 
Top