smoke on start up

kmack

Donating Member
1993 typhoon 50,000 mi
starts great runs great, but puffs smoke on start up,oil consumption not noticable but annoying when starting.
Any ideas about cause
VALVE SEALS ??
TURBO SEAL ??
Any easy troubleshooting tips ????:rant:
 

Davemc1963

93 Ty Owner
Re: smoke on start up

It could be your valve guide seals, but it could be that you have too high an oil level or possibly too thin an oil. I used 0/30 a couple of changes ago and it smoked on every start up. Now an occaisional puff. Considering its age and mileage, I consider that OK, but no puff would be better obviously. Burning oil increases chances of pre-ignition, something everyone on here needs to avoid.
 

Logan

Member
Re: smoke on start up

x2 on warm pancakes. That one I can guarantee you. As the engine cools oil seeps by and is burnt on start up. It is a simple fix that I have done on a few cars. My first time I googled it and got to it. The only precaution you have to take is either pull the spark plug and get some nylon rope to stuff in the cylinder so the valve doesn't fall (redneck way, I am from Oklahoma......'nuff said) or there is a tool that attaches to an air hose and keeps the valve in place. Other than that, 4 hours and a 6 pack of your choice of adult beverages. Good luck with it.
 

TNPhoon

1of28
Re: smoke on start up

IIRC, at Shindig, GShan had mentioned something to me about using brake fluid to fix minor smoke issues. Although I could have been so buzzed that I merged two of our conversations together and one didn't have anything to do with the other. Since I am not 110% sure, I'll let Guru Gary chime in if he happens to see this post.
 

5678TA

New member
Re: smoke on start up

you could also check your turbo for play. just pop the orange boot off and grab the impeller shaft. just a bit of side to side play is ok. any in/out play, then you should rebuild and more than likely your seals are gone. a bit of oil near the impeller is a sign toward turbo seals. mine is loose and leaks oil. smoke on start up. then again, i probably need new valve seals too. 126k on mine.
 

Logan

Member
Re: smoke on start up

so where can I get the valve guide seals? Brand recommendations?
SycloneRob you can get them at any parts store. Nothing special about them.

Anybody feel free to correct me if I am wrong but they don't experience wear, more so aging from expanding and contracting as the motor heats and cools.
 

kmack

Donating Member
Re: smoke on start up

It WAS valve seals!!!!!

There was quite a bit of oily residue throughout the entire intake system but it was just that RESIDUE, not the result of a bad turbo seal.:tup::tup::tup:
 

kmack

Donating Member
Re: smoke on start up

It WAS valve seals!!!!!

There was quite a bit of oily residue throughout the entire intake system
but it was just that RESIDUE,
not the result of a bad turbo seal.:tup::tup::tup:
 
Top