Solving overboost problem??

Hey guys,
Installed minigaten on crossover, welded integral wastegate shut on turbo, and vac line from turbo port to side port of minigate. I also has a regulator tee'd in on the same line off the turbo and running to the top port of the minigate. During a run you will see boost keep rising in one PSI increments, until it hits about 18-19psi and then the ultimate cuts fuel out. Now I thought it must be the regualtor causing all the problems, so I shut the regulator completely, then what I get it the boost starting at 8psi and running up to 12-13psi by the end of my run. So this sort of told me that the regulators is not the problem. You guys think this is a bad minigate?? Its only been on for 2-3months??
 

ghettosled

SYTY SUPERSTORE
so all you have is the vacuum line going from the turbo compressor to the side of the minigate?? Do you have a pic of the minigate mounted? What do you have for turbo and exhaust? The minigates typically hold boost quite well. U mention 2-3 months, was it working better before?
 
I have the vacum from compressor to a Tee, then one side of the Tee to the side of the minigate, and the other line from the Tee to a regulator then to the top port on the minigate. Then I completely closed the regulator(so I d be running just in base boost), and the results were like I stated above. I dont have a pic, but its mounted on the X-over just like all the pictures Ive seen of everyone else setup. Turbo has a 20g compressor, and 12cm2 exhaust. I just installed the minigate over the winter while the truck was of the road, so with the stock integral wastegate I was not overboosting, but the boost fluctuated alot. It would go from 12psi-15psi, back and forth. It doesnt do that anymore, but it does keep increasing boost like I said. For exhaust Im running stock DP and a cat?? Do you know of anything I could check that would cause this?? Thanks for the help Mike. Fern
 

ghettosled

SYTY SUPERSTORE
yeh your regulator is probably leaking. Run only a line from the compressor housing to the side of the wastegate and you should see a steady 10-12 lbs throughout the run. Leave the top completely open. Once you confirm that the minigate is running like it should, you can then work on buying a better regulator.
 
Mike, did alittle investigating tonight and found the problem....
I look under the truck to make sure I didnt switch the lines running to the wastegate and they were fine. But what I did find was that when I reinstalled the lower heat exchanger, the two vacum lines got crushed between the cooler and the frame(I think??). Ne ways rerouted the lines and all it good. Listen, I wanted to apologize for jumping to any conclusions, but Im sure more people will run up to a problem like this in the future. Neways, thanks again for the advice and help. Fern Sy#477
 
Top