some intake leak questions....

gmcturbo

Active member
my truck like to stumble and miss at idle and throughout the rpm's. im pretty sure it's an intake leak. when i start my truck up the IAC counts continusously go down finially to 1. does this tell what my problem is? has anyone had this same problem and fixed it with an intake gasket replace?

thanks

mike

93 ty 731
 

SY2932

Administrator
Myclone posted something about this many moons ago. In his case, the bolts holding his upper intake on were loose :eek:... Simply tightening them solved the problem. HTH's

Mike Campbell
 

myclone

Donating Member
In my situation the bolts were loose but it wasnt leaking that I could tell (IAC counts were fine).

I dunno what all you've checked but before I would replace the intake gaskets I'd replace the stock vacuum lines and rubber elbows. If they are the stockers then thats prolly where your vacuum leak is. However, it prolly wouldnt hurt to check the upper to lower intake bolts to make sure they are tight.
 

gmcturbo

Active member
the only hoses i have replaces are the FPR to intake to MAP. i have run top end cleaner, full recent tune up (msd,conrad, cr42), new 2 bar map, AFPR, johnson pump and hose conv., pcv,

i will block off the other hoses to see if it is them leaking.

exactly how do the iac's correspond to vaccum leaks?

-edit BTW im not throwing any codes...


thanks

mike
 

InvisiBill

Active member
IAC is Idle Air Control. It opens and closes to adjust how much air is let in while the throttle blades are closed at idle. Normally, they're like upper teens to low 30s, I think, depending on the truck. If they're going down to 0, then you have a vac leak somewhere. The IAC keeps closing more and more to try to let less air into the intake, until it can't go any more (at 0).

Use the bike tube trick to find leaks. Cut a bicycle innertube so that it's not a "donut" but a "tube". Seal up one end (I think you can just fold it over and clamp it) and seal the other one to your intake (IC opening, for example). Hook up your bike pump to the innertube's valve stem and start pumping. This will pressurize the intake and you should be able to tell where your leak is. Note that check valves may hide the problem if the leak is right at an accessory or something.
 
Top