stalling after boosting?

E-Rue

New member
when i drive the truck lightly, it idles and runs good.
when i drive it into boost for a little while, after i stop it stalls, and doesnt want to restart. is this similar to the hot restart issues like brian was fighting in the 50lb chips? im totally lost as far as what to adjust to remedy this problem.

e
 

smeagol

Active member
Well we have 2 issues here - the stalling, and the no restart...

Could be caused by 2 separate things, could be the same problem causing both.

I'd check logs to make sure that you aren't looking at calibration, when you should be doing regular mechanical checking up ...

Now .. does it stall at a very strong deceleration, or anytime you are just tooling along, or right as you go from part throttle to no throttle...what is the load on the engine...describe...or post screenshots of your run. Could be a matter of adjusting your deceleration fueling. What kind of IAC numbers do you see at idle? Adjusting the throttle shim may help/hurt.


Restart thing - Could be as simple as adjusting this table at hot temps:

0x0551 F54_TABLE Crank AF vs Coolant Temperature
Ratio
| -40 28 -16 -4 8 20 32 44 56 68 80 92 104
---------------------------------------------------------------------------------------
(Ratio) | 2.9 3.2 4.0 5.1 6.0 7.0 8.0 9.0 9.5 10.0 10.5 11.0 11.0

lots come into play here, you have to make sure you are using the right table to correct your problems (if it is in fact a calibration issue. This is why you have to ask so many questions when fixing a problem like this.
 

E-Rue

New member
cool! really appreciate the response.

coasting/decel seems to be fine. its when i come to a stop, it trys to die. if i do let it die its hard to restart. i have to hold throttle about half way and then crank it.

if i get out and let it set, to cool down, it will restart fine. if i try and start it right back up, it keeps trying to stall again, untill i drive it around a little bit. then it seems to be back to normal. its not over heating..... ill record it doing it a few times and studdy it. look for similarities or whatever.

e
 

leroy

Donating Member
Make sure the IAC is good. That's a classic symptom of an IAC that needs cleaning.

Jim
 
Top