Stalling,Rough Idle...

GMCSyclone1

NASTE MEMBER
My old man has had my truck for a bit since I have been busy with work. Long story short, he has replaced the exhaust for me which was a nice gesture but he did eliminate the cat and obviously the O2 sensor. For obvious reasons the truck would shutter occasionally but never really stall. The truck is mostly stock and I do not have a chip. I have recently done a complete tune-up and redid all the vacuum lines. Anyways I live in MD and he has had the truck in WV. Today coming back to MD the truck would stall on him and he would need to wait a bit before it would turn over again. It mainly did this when coming to a stop, I understand the truck is trying to compensate with the elimination of the O2 sensor and I am sure the brisk air is causing it to do so even more than usual. I guess what I am asking is since I am very limited on time at the moment are there any reputable shops in the MD or surrounding areas that could take a look. I am not sure a chip will alone fix this issue but if so I need to go about purchasing one and finding a shop to handle the installation. Any ideas, references, feedback welcome. Thanks for taking the time to read.
 

jeepruby04

New member
Re: Stalling,Rough Idle...

Not sure I'm reading this right, he is driving the truck with NO o2 sensor? Unless he changed the down pipe I can't imagine why the o2 sensor would be removed. I'm no expert but I'm pretty sure it will never run right without the o2 sensor.
 

randy merritt

Donating Member
Re: Stalling,Rough Idle...

Not sure I'm reading this right, he is driving the truck with NO o2 sensor? Unless he changed the down pipe I can't imagine why the o2 sensor would be removed. I'm no expert but I'm pretty sure it will never run right without the o2 sensor.

Agreed, closed loop fueling does not work with no O2 sensor.
 

Couger1968

Dazed and Confused
Re: Stalling,Rough Idle...

I am not sure Saudi syclones had one. They ran on regular gas and I didn't think O2 sensors worked with it. American ones definitely do or they wouldn't run closed loop.
 

GMCSyclone1

NASTE MEMBER
Re: Stalling,Rough Idle...

I will double check I am going based off of hear say but I haven't even had the truck up in the air to look at the exhaust that was installed. According to what he believes from the exhaust installation it was removed for whatever reason. That being said since he has been in the slightly warmer climate the truck has been running great. If the O2 sensor is in place then I am not sure where to go next mainly because I just currently do not have the time. Is there anyone that could recommend a shop around the MD area that he can take it to if need be?
 

powercat6

Active member
Re: Stalling,Rough Idle...

I am not sure Saudi syclones had one. They ran on regular gas and I didn't think O2 sensors worked with it. American ones definitely do or they wouldn't run closed loop.

You're right Saudis had no operating O2 sensor, but they also had a Memcal in the ECM that was tuned for leaded fuel. :tup:
 
Top