Christian Dionne
Member
This is gonna be long, so here goes...
When I unplug the tan wire, to set timing at 0 degrees, what exactly happens?
I thought that timing should stay at or near 0 no matter what the rpms with it unplugged.
When the Ty is cold with the timing light set up, I start it up with the wire unplugged. It idles pretty high for 30 seconds with about 17 degrees of timing. Then it comes down to 600~rpm and the timing shows 0 degrees. I can then rev it up and timing will jump to 30-40 degrees. Is this normal?
Is my MSD distributor's ignition module screwed up, or maybe the reluctor? I have unplugged my 7AL-2 and HVC coil and put the stock coil back on. Still have something weird going on where more than 1/4 throttle results in a retard like state. It starts popping like a PRO 5.0 car on the line and boost comes way up. With the tan wire unplugged it idles like shit of course, but jumps right up and runs alot better with 1/2 throttle. Still isn't near perfect but is much better than plugged in.
I have a stock distributor with a bad ignition module to try if it might be the MSD reluctor. I hate to swap it in with the MSD module, just to have nothing happen if it was the module anyways. I guess I need Datamaster so I can check timing with the tan wire plugged in and match it with the Snap-On light.
Is there anyway a chrome timing pointer for a SBC is in the wrong location for a V6? Is there anyway a Fluidamper balancer can be off on its etched timing marks?
When I unplug the tan wire, to set timing at 0 degrees, what exactly happens?
I thought that timing should stay at or near 0 no matter what the rpms with it unplugged.
When the Ty is cold with the timing light set up, I start it up with the wire unplugged. It idles pretty high for 30 seconds with about 17 degrees of timing. Then it comes down to 600~rpm and the timing shows 0 degrees. I can then rev it up and timing will jump to 30-40 degrees. Is this normal?
Is my MSD distributor's ignition module screwed up, or maybe the reluctor? I have unplugged my 7AL-2 and HVC coil and put the stock coil back on. Still have something weird going on where more than 1/4 throttle results in a retard like state. It starts popping like a PRO 5.0 car on the line and boost comes way up. With the tan wire unplugged it idles like shit of course, but jumps right up and runs alot better with 1/2 throttle. Still isn't near perfect but is much better than plugged in.
I have a stock distributor with a bad ignition module to try if it might be the MSD reluctor. I hate to swap it in with the MSD module, just to have nothing happen if it was the module anyways. I guess I need Datamaster so I can check timing with the tan wire plugged in and match it with the Snap-On light.
Is there anyway a chrome timing pointer for a SBC is in the wrong location for a V6? Is there anyway a Fluidamper balancer can be off on its etched timing marks?