Timing question

Don W.

Stab it and steer it
Howdy,

Finally put a (non adjustable) light on the Sy with the wire under the dash disconnected and the mark is prolly ½ in to the right of TDC, retarded. Hook the wire back up and it’s way advanced which I assume is correct. I can do a TDC check but how often do we find the damper has actually slipped? Or do I just go ahead and bring it back to “0”.

Being an old breaker point guy I would think that if I change the advance doesn’t that affect knock? Or do the electronics take care of all that?

Thanks,

Don
 

gmcturbo

Active member
Re: Timing question

go ahead and just check tdc then set to 0. its just one less thing you got to worry about ya know...

after you set your timing you may want to pull the ecm fuses if youre concerned with the computer re-learning.

hth
 
Top