Timing

GEN3Typhoon

New member
Ok so I have searched through the posts and have found nothing additional that will answer my question.

I recevied some information at the Nats that I am still confused about.

I set the speed pro in my truck to 10 degrees
I set the distributor with the brown wire unhooked to 10 degrees

In the timing table at idle I have it set for 26

So do I have 26 degrees of timing at that point or do I have 36 degrees. I asked four different people and got four different answers.

TIA
 

smeagol

Active member
If you put 10 degrees advance in the table for Speedpro, you want total advance to read 10 degrees when you put a timing light on it, with the tan wire connected. You want the table to reflect the ACTUAL timing your engine is running at.

How you get there doesn't matter, just as long as your timing read with the gun is the same as what you pu in the table.

With that said, if you set the distributor to read 10 degrees advanced with the tan wire disconnected, you have set a base timing of 10 degrees advanced. If you go and put the reference angle setting in Speedpro at 10 degrees, your timing table advance values will be accurate, as the Speedpro will take the reference value into account.

So here's what ya do.

First, make sure your balancer is accurate to true TDC. If you have a fresh engine, I'm hoping you did this during the buildup, or on a stand.

Ok, now, run the engine. Don't touch the tan wire yet. Run the motor, read the timing on the balancer, compare it to that of the Speedpro readout. Are they the same? Good, you're done. Are they different? If yes, you can either turn the distributor until they match up, or adjust the reference value in Speedpro.
 

GEN3Typhoon

New member
So I need to get a timing gun that I can dial advance with in order to really to do it correctly?

When it is idling at 26 degrees I need to be sure it is ready the same on the advance on the gun.

With the base setting on the computer set to 10 degrees and the tan wire disconnected I have 10 degrees at the balancer. So I am assuming this is right.

What I seeing is as long as the speed pro and the distributor setting are the same.. the advance I see on the computer is the actual advance.

I hope I am understanding right. I think it is set right. So many questions. I think I have some other issues too but that is more to come once I have time to be sure what I am looking at.

Thanks for the help.
 

GEN3Typhoon

New member
so reading another post.. I really need to have a timing light I can dial the advance in at idle. I should not have the motor running when I have the wire disconnected and am checking base timing?

I can get a gun that will show advance so I can dial it to what the motor is showing.

Thanks again.. sorry to reply to my own post, just thinking outloud.
 

smeagol

Active member
No, it's not necessary. It's nice, but not necessary.

If you read 10 degrees advanced on the balancer with a regular gun, using a gun with advance, you'd set it at 10 degrees and see zero. Not a whole hell of a lot of difference.

Yours sounds like it's set correctly.
 

GEN3Typhoon

New member
Thanks... also I was told that the maximum that the FAST would retard the timing is as much as you have it set on the balancer. So it if I have it a 2 degrees it would only be capable of retarding 2 degrees...?

This did not make sense to me but I had two people tell me that also.
 

smeagol

Active member
That doesn't make any sense to me. There is no mechanical limit for that situation.

I can't verify that I'm correct either though.

There is a maximum ESC retard in the Speedpro cal; you'd think it would back up to your reference angle if that was the case.

Call up Lance or Harry or someone to get the lowdown on it.
 
Top