TPS dip at WOT

smeagol

Active member
First off, your truck was 211° F during that blast, so I have to curse you out for running your truck that hot.

I'd try a new TPS to see. Your voltages don't look *all* that bad, though there are some low spots.
 

92Ty#1524

New member
I have doubts about my temp (as you noted). My dash and the ECM sensor are split by about 35 degrees. I dont know which one is telling the truth. In that file you saw, my dash was reading just under 185.
 

Ian Turgeon

Cascading Inspiration
I'd give the computer more weight then the swingy arm thing in the dash.
Get that figured out soon.

Did you let off the gas where the dips are in the run?
Is this a bad dm run? or are those dips unintentional?


Your getting enough to go 100% TPS if the dips corrisponded to you letting off the gas, so I wouldnt see a problem there.
 

92Ty#1524

New member
Thats just it. I had my foot planted solidly against the firewall untill I let off and coasted about six seconds later. I noticed the TPS dip about 2 seconds into the run when it shifted up to the next gear. I did it again last night and got the same result. I might also note that I didnt feel as though the truck was letting up. The power felt continuous while accelerating. I only noticed the dip when I went back and looked at the data.
 

sytyguy

Moderated User
I remember that my Dad's S10 had a similar problem (his a bit more severe). You could be driving and the thing would start surging. Come to a stop and you had to pedal it sometimes to keep it from dying. Never tried WOT with it for the pistons sake. I heard about the symptoms from him and went over to take a look. Hooked up scantool and went down the road. TPS would randomly jump all over the place acoompanied by lean/rich mixtures and bogging/popping/fallin' on it's face. Tried known good TPS and all was well. Heaved old one into woods.

My bet is on TPS. Best to rule out the obvious first (meaning - don't replace the ECM/wiring harness/etc....before trying the TPS itself).

Michael
 

Daron

Active member
I had a TPS change readings randomly. I replaced it with a ACDelco unit and all as been fine since.
 
Top