TPS Setting

GEN3Typhoon

New member
I have the Speed Pro setup and I am adjusting some things for idle.

I notice the TPS is sitting at 11%.. just for kicks, I turn off the truck..key still forward so the ECU is still sync'd and to the floor it only shows 75%

I am assuming of course this is wrong.. ;)

So I have been looking for the procedure to reset the TPS and I have searched far and wide in the SYTY CD and cannot find it.. any ideas.

I know the sensor is 0-5V and I think the idle was 0.50V and WOT was anything from 4.9-5.0V.. anyone have a copy or tell me what page in the manual it is on.. sorry for the question to the list... I have looked for more than an hour for it.

TIA
 

nightdiver

Active member
I did mine 20% at idle and 91% wot
Had to correct the idle parameters then
Runs fine spesialy with the 22* advance at 197 kpa and up :eek:
 
Top