Tps

Neelsonwheels

Donating Member
Can ayone tell me what my TPS should be at idle.
I am running Big stuff and from what I can see it is seeing 4%.
I was wondering if this is wrong and causing a high idle.
Thanks
 

sly dvl

Ya, it's got a Turbo
Re: Tps

Should be between .40 - .60 volts. Percentage is just a value calculated by the software. If you're sitting at 4% then at some point it had to be 0%, which suggests your throttle is sticking a bit. Try shutting the truck off and then turning the ignition back on without touching the pedal. If it now reads 0% then the bushings in your throttle shaft are worn and causing the plates to bind at idle under vacuum.
 

MRKING

New Parts for Old Trucks
Re: Tps

I had a similar not zero tps issue with my 80e controller . When i removed the tps and held it in my hand while plugged in, it still would not go to zero .

It has to be a voltage related issue somewhere . As long as you get 100% tps @ wot , 4% @ idle can be worked around . You getting 100% ?
 
Top