tunerpro VE table help

BMFB

Not to scale
Ok, so ive been doing some tuning for a couple days, i have a stock motor, open cat, fuel pump, couple little things like that but nothing big. I believe im using digs stock bin form the code59 website.

Now, the trucks seems to be running great, although i do have a few other questions ill throw in at the end, but my main one is, why does my table look so screwed up? I dont have a pic i can give now, but it looks nothing like the beginning one did. It has a big series of troughs in the middle of it where im doing gentile acceleration, decel, and where i cruise, and then huge steep inclines around it from where i do hard accel, and boost. those are right in where it looked like the original power curve was, but thats gone entirely, and around where it was (like a big j, starting low kps and low rpm, like a boost launch, and going to the far side of it and forward int he rpm and 190 kps range). like i said, it runs pretty well, but im worried my accel enrichment tables or something arnt working. I noticed the egr wasnt on in any way from the stock bin, any ideas?

Also, seem to have some weird knock that happens at arn 12psi. It will be fine, then when it shifts it will jump to like 8* and ill back off and it will go away. my fuel ratios are real rich, 11.3 to oneish, what else could be causing this? im wonding if its false, as ive never heard actual tinging, never.

am i retarded?:myclone:
 

BMFB

Not to scale
Re: tunerpro VE table help

i can say that i was running at 15 psi with no KR until i shifted at about 80 90, then i got like 6* of the stuff, with no noticeable change in boost pressure, and very little in AFR, i can say that ive had the same thing happen at 17-18 psi, but im not sure how to track down false knock...i do know somethings wrong with something in my serpentine belt system, makes a slight banging at idle....
 

JSM

Active member
Re: tunerpro VE table help

During a shift the RPM changes obviously, load changes, boost is about the same. I suspect the area of the fuel table with lower rpm but higher boost 200kpa range based on your figures is off. Rich will cause knock as well as lean. Sometimes you have to compromise also as 2 parts of table may have significant different loads.

If your using autotune keep in mind its just a starting point and the big dips/valleys will probably need to be smoothed out manually. Approach that process slowly many small steps is much better than 1 big step.
 

BMFB

Not to scale
Re: tunerpro VE table help

alright, thats good to know, i wasnt sure if rich could cause knock, thanks alot man
 
Top