tuning alky on custom chips?

jbone

Member
Im planning on getting alky injection but it wont happen until after I get the truck tuned w/ a custom chip. My question is: After the alky is installed do you have to have your custom chips sent out and reburnt to account for the use of alky? For instance while running higher boost, and timing? Im just trying to figure out the steps ill need to take when all this goes together. thanks
 

LandryPoole

New member
Re: tuning alky on custom chips?

From what I know about Alky, I'd say, first run Meth, second, all the cooling affects of the that the Meth produce allow for more volume of air at any given boost. You just tune for the boost you plan to run. If you currently can run 17.5 psi without Meth, then you might be able to run 20 psi with Meth. Or, you could still run 17.5 psi, but at the end of the strip when your IC is getting hot, your Meth kit would be keeping things under control, and preventing mr. knock sensor from working. At least that is what I know.
 

sytyguy

Moderated User
Re: tuning alky on custom chips?

To get the most out of A-M-W Injection, you need to be able to tune your fuel maps (especially by WBO2 if possible). You can make it liveable by turning down FP, but you can unveil much more power when properly chipped. There won't be a ton more chip work to do after the install (mostly pulling out fuel), so maybe you can get a quick retune afterwards (or just wait until the install is done to get the chip.)

Hood
 
Top