tuning question.

Neelsonwheels

Donating Member
My Typhoon had been running pretty well but I felt it was a little lazy right off the line,and it had a little buck or hesitation that I could not remedy. After exhausting all other things I felt it
had to be a timing issue. The truck was tuned very well by someone who knows these trucks well "remotely". I changed the harmonic balancer thinking it was slipping and causing an issue. After it was tuned. The truck still missed so I started looking into the tune in Bigstuff.
I set the test timing to 30degrees and verified that it was spot on. It was at idle. when I raised the RPMs the timing would drift. So I set out to set the inductive delay to stop the timing from drifting. It was drifting between 4 and 5 degrees. After the delay was addressed the truck runs rich at idle. I want to remedy this rich condition but don't know if I should do it in the fuel tables or by backing off the timing. As you can tell I am know tuner. Any input would be great.Thanks in advance.

Neels
 

WyoSyclone

Active member
Re: tuning question.

My Typhoon had been running pretty well but I felt it was a little lazy right off the line,and it had a little buck or hesitation that I could not remedy. After exhausting all other things I felt it
had to be a timing issue. The truck was tuned very well by someone who knows these trucks well "remotely". I changed the harmonic balancer thinking it was slipping and causing an issue. After it was tuned. The truck still missed so I started looking into the tune in Bigstuff.
I set the test timing to 30degrees and verified that it was spot on. It was at idle. when I raised the RPMs the timing would drift. So I set out to set the inductive delay to stop the timing from drifting. It was drifting between 4 and 5 degrees. After the delay was addressed the truck runs rich at idle. I want to remedy this rich condition but don't know if I should do it in the fuel tables or by backing off the timing. As you can tell I am know tuner. Any input would be great.Thanks in advance.

Neels


Should adjust the AFR via the fueling table. I've never seen BigStuff, so don't know the tables.
 

Sportmachines

Active member
Re: tuning question.

Def do it in the tune. Lean out the target AFR at idle. I know we had a bit of trouble with it last time finding its sweet spot. Might take some trial and error.
 

Neelsonwheels

Donating Member
Re: tuning question.

Thanks guys!! I'll do it in the fuel tables. I learned a little from Alex. Enough to be dangerous!!
Lol. Tom I was planning on heading to Carlyle but my son is off to college and we have to
get him setup on campus on that weekend according to my wife (the boss).
 

autoaddictions

Active member
Re: tuning question.

Make sure engine is up to temp first. I will be at the meet in carlise and im fluent in big stuff I may be able to help .
if you want email me your tune ill look it over Fdeninno@comcast.net might not be a bad idea to log 60 sec or so of idle and send that too.
 

Neelsonwheels

Donating Member
Re: tuning question.

i am still considering heading down to Carlisle. I might just trailer the truck down even though I am not registered. Thanks for the help folks. I went out last night and reloaded my saved tune with the updated inductive delay and the AFR at idle was at 13 to 1. I think I may have screwed up and tried to load a calibration with the engine running. It is running nice now but I still get a buck occasionally with light throttle. Who knows why? I am just happy it is running!!
Little victories.
 
Top