Tuning

akwilks

Mr. Keith
Frustrated and way over my head with this Ty. Patience wearing thin...Is there anybody that can recommend a shop to tune my Ty? I live in Rapid City, SD and dont object to having to drive out of state to get this done....within reason of course....I cant even swap a chip without have some kind of driveability issue...Initially I just wanted a turnkey vehicle but I was unprepared for what I experiencing now...I have 50# inj, hi flow fp, upgraded ic pump, garret turbo, adj fpr, 3bar map, no cat, 3" custom exhaust, cone air filter. With a 2bar dynotech chip i have no issues but once I go to a 3bar chip everything goes south...engine temps rise, 12-16kr, and overall lackluster performance...with ur6s and fp set at 45psi I thought It would do fine....not the case....so I have removed the chip, went back to the 2bar chip and will have to have it tuned to find out whats going on with my ty..any help is greatly appreciated since I'm about ready to sell my truck and buy a yugo...thanx
 

SeattleSy#1255

Category 5 Conservative
Re: Tuning

Yup

www.raceprovenmotors.com
Mike Lee

In LA...so not to bad for you.

Do you have a stock chip..sometimes the best thing to do is go back to stock. So 2 bar chip and 2 bar map sensor. Also, are you sure 100% the map sensor is a 2 bar and a 3 bar (the ones you are using)?

What ignition components are you using besides ur6's...cap/rotor, wires?

Replaced all the vac. hoses yet?

Also, with 50# injecters you HAVE to have a chip that is burned for them...a stock chip or a regular 3 bar burned for a stock truck won't work. In short, you can't put a 2 bar or 3 bar in and have it run right unless it is burned to match 50# injecters. So scratch what I said above.
 
Top