Turbo Coolant Line Fitting

I'm trying to connect my stock turbo coolant return line and I'm not sure if I need two washers or just one. It's the banjo fitting with the big bolt that has a hole in it. When I removed it, there was a brass washer on the head of the bolt, but I'm not sure if one goes between the fitting and the turbo. If there was one, it fell off when I disconnected the line and I can't find it. Any help would be appreciated. It's the only thing I have left to install to have my upgraded stock turbo back on running.
 

ViciousV6

400HP/550FTLB
Re: Turbo Coolant Line Fitting

HAMMERHEAD said:
I'm trying to connect my stock turbo coolant return line and I'm not sure if I need two washers or just one. It's the banjo fitting with the big bolt that has a hole in it. When I removed it, there was a brass washer on the head of the bolt, but I'm not sure if one goes between the fitting and the turbo. If there was one, it fell off when I disconnected the line and I can't find it. Any help would be appreciated. It's the only thing I have left to install to have my upgraded stock turbo back on running.

You need one brass washer on both sides of the banjo fitting! 2 Washers total!

Ralph
 
Re: Turbo Coolant Line Fitting

Thanks, I 'll pick up a couple of new ones somewhere tomorrow. Do you think I could fine them at a auto parts store ?
 

TYHOGG

Active member
Re: Turbo Coolant Line Fitting

You could try Ace hardware they have a large selection of copper bushings/washers at the one near me. Haven't looked for those yet.
 

socalblue

New member
Re: Turbo Coolant Line Fitting

I lost that washer too luckily my buddy found it about a week later inside the frame rail if I remember correctly or somewhere near the frame...he laughed at me for a minute because I was tellin him he'll never find it. I always lose stuff. One of the washers is thicker I believe the thinner washer is the one that contacts the turbo. The thicker one goes on the outer part of the banjo fitting.
 
Re: Turbo Coolant Line Fitting

I found the washers at Pep Boys. The copper washers that go on a oil pan bolt are the same ones. They come in different sizes. They are also called thrust washers. I got the banjo fitting on, filled the intercooler and radiator, and started the truck. Ran it till it was at normal temp and had no leaks. Now all I need is for the weather to clear up so I can take it for a ride. Can't wait to try out the upgraded stock turbo.
 
Top