Turbo housing question

TYHOGG

Active member
I'm looking to upgrade my turbo for the 3rd time. I want to go with the PTE67GTQ my question is which cover fits with a/c? H,S,E? I have been told the E-cover 3"in/2out fits ok, but the S-cover 4"in/2", H-cover 4"in/3"out do not, is it possible to make either of the larger 2 to fit by trimming the a/c braket, or switching to March brakets? Is it even worth the time, does the larger inlet give me more power or decreased temps? I'm looking to pruchase in the next few weeks after i recieve a definitive answer.

Thanks in advance,
Adam
 

MikeRenz

not stock
Re: Turbo housing question

are you running stock (atr/kb) manifolds, or custom? What exhaust housing do you have on the turbo.

To tell what (should) fit why not just take some measurements of your current cover in relation to the A/C bracket...and get overall measurements of the cover(s) in question. No one here (aside from a vendor w/ all the covers in stock) will be able to just answer your question for you. You're going to need to do some research on this.
 

TYHOGG

Active member
Re: Turbo housing question

Thanks Mike. I have the stock manifolds right now, with a 14cm 20gh. It fits with little clearence, I'm not sure if the intake housing gets a lot bigger or the turbo companies enlarge the internal dimensions. I haven't found much in the way of measurements off any sites. I was hoping someone might be running a "S" cover and still have a/c. I'll try and make a few calls today to look into it. Thanks for the feedback.

-Adam
 

JSM

Active member
Re: Turbo housing question

I have installed a 67dbb turbo on daron's, with the 4" inlet and AC

Tight but fit fine. The pte housing move the turbo out and away from engine so the centerline of your 20g is not the same as the 67 so you can't judge based on that.
 

MikeRenz

not stock
Re: Turbo housing question

I'm fairly certain there are some s-covers (isn't the gt35r an s-cover?) out there. but every turbo is going to be a little different, center section will put the center of the turbo in a different spot.




edit: i see jeff chimed in w/ his experience.
 
Top