ultimate street/strip

i8av8

Donating Member
i have the old ultimate street/strip box that uses the key to lock/unlock and my question is: are they suppose to jump settings? i set it to 15psi. street (t1) the first setting and turned the truck on and in idle the ultimate jumps to 16psi. street (t1).
i go on a test drive and get to wot>go back to shop and in idle the ultimate goes to valet. what the hell?!!!!
 

KETCH-UP

New member
Re: ultimate street/strip

Mine used to do that sometimes when I had a msd-6 installed. I put a .1uf capacitor across the "pic" bank switch processor power pin to ground. After that it only happened a time or two. Since then the msd went bad and the problem never occurs.
 
Re: ultimate street/strip

I think its basically a connection/ground/bad cable issue. Mine will do that if the connector on the back of the controller is not pushed down all the way.
 

i8av8

Donating Member
Re: ultimate street/strip

so basically i'm screwed. i'll recheck connections. thanx for the replies
 
Top