Ultimate

Sy769

Donating Member
BG What issues do you think I will have with the Ultimate and will the calibration be close with this setup? If you don't think the ultimate will work prolly go with fast or accel once I convince the wife. :wink:
Built short block (eagles JE 4bolt)
Ported stock heads with 2.02 &1.6 valves
1.6 crane rockers
stock turbo-ported wastegate
KB A2A
CAM -undecided comp cams 09-412-8, 09-415-8
or 09-422-8 I remember you mentioning one of these cams before just can't remember which one.
I need the new cam just don't want to pick the wrong one and end up way out of calibration.
Thanks
 

smeagol

Active member
Have you already built this, or are you still in the planning stages for this build?
Let me know so I can answer appropriately :wink:
 

Sy769

Donating Member
Uhh both :grin:
The engine is assembled most of the way.The original was trashed when I bought the Ty. I built this one so that as time and money allows I can go with 50#/PTE combo. For now I want to try using the ported stock turbo and rebuilt injectors since I already have them. I don't have a usable cam so i want to upgrade if the ultimate's programming will work. Kinda hate to spend money on a stocker and then buy another when I change bolt-ons.


_________________
Patrick Johnston
Syclone
92 Ty

<font size=-1>[ This Message was edited by: Leardriver on 2002-02-21 17:28 ]</font>
 

Sy769

Donating Member
So what do you think? Will one of the comp cams or the crane .430 with the other mods change the VE #s enough that I'll have calibration issues or can I compensate with fuel pressure? If the ultimate works then later at some point I can upgrade the turbo,ecm an injectors and already have the better cam in place.
Open to suggestion Thanks
 

smeagol

Active member
Well you should really go with some combos that are/have run well. I can't guess as to what will run well. I do know that I can get you some calibrations that will work well for the following:

Ported L35s & ATR / .430 Compucam, mild turbo & 50s

mildly worked Vortecs & Comp cams 412 grind & 50s for mild turbo

I can't promise anything as far as performance/drivability/emissions for those setups however.

Bill Calcagno has a good combo up and running, and can probably help you with the calibration as well. He has heavily ported L35s, ATR cam, stock exhaust manifolds, PTE turbo & single core air-air and the 50s for fueling. I know his drivability was really going well, but he had to redo his WOT fueling for the new turbo & air-air setup.
 

Sy769

Donating Member
Thanks Brian. Just was curious how flexible the Ultimate would be to the parts I have. How do I get in touch with Bill. For the time being I have to use the ported stock heads that I have and stock turbo/injectors. I think I will try the mildest comp or the crane and the ultimate. If it doesn't run well I can always use the ultimate on the stock Sy . I'm not in a hurry since I don't have a place to finish reassembly anyway for a several months :sad:

Anyone tried one of these cams with stock turbo/injectors and the ultimate or something close?
 
Top