Ultimate ???

TYHOGG

Active member
If i run a 160* thermo can that cause a check engine light with the ultimate only at idle? I cannot for the life of me figure out anything else that could be cause it. I might just pick up the 180* at Autozone and swap it out just to see it if takes care of the problem.

Thanks,
Adam
 

Flyin Ryan

hated cuz he drives fords
Re: Ultimate ???

Check to see what code it's giving.. then pull the ecm fuse and see if it re-occurs
 

TYHOGG

Active member
Re: Ultimate ???

how do you check the code its trowing with datamaster? the "check engine" light only comes on at idle after it has been running for a while. While its on it will hold the truck to 5psi. Once i start moving a few blocks it will shut off and i will get full boost again.
 

TYHOGG

Active member
Re: Ultimate ???

alright i figured it out. It was the 3 bar map sensor. i went back to the original (atr/2 bar) and no check engine after driving around for 1/2 hour. I'll pick up a new 3 bar tomorrow, and see if its the ultimate causeing the problem.

Thanks for the help guys,
Adam
 
Top