Vacuum ports on intake

JAY

Donating Member
Is there any difference between the front & rear vacuum ports? The reason I ask is that I reran & replaced all my vac lines. I used the routing diagram from the Syclone spec manual. I changed the vac line to the HKS BOV so it is coming off the front port Instead of the rear. I am now having a boost leak & wasn't sure if this port was lessor/metered/different than the rear. See pic below. (marked in red)

 

Don W.

Stab it and steer it
Re: Vacuum ports on intake

The answer to your question is no. Just don't use the small port coming off the bottom of the TB. That is different.

IIRC the rear port only went to the MAP sensor and FPR. I'm guessing they did this to keep the lines short and to avoid the potential for haywire reading from the other line because of all the different places it went.
 

DaveP

Active member
Re: Vacuum ports on intake

IIRC the rear port only went to the MAP sensor and FPR. I'm guessing they did this to keep the lines short and to avoid the potential for haywire reading from the other line because of all the different places it went.


The FPR and MAP need a manifold source that is more stable, and indicative of actual manifold pressure at all times.

That's probably why they're plumbed to different ports. I've never really thought about this before. Thanks Don for the "food for thought".
 
Last edited:

JAY

Donating Member
Re: Vacuum ports on intake

Thanks for the help. I will get this changed over. I had a feeling I might have an issue when I plumbed it.
 

Damian

Member
Re: Vacuum ports on intake

The "other places it goes" are the HVAC doors, cruise control, and EGR valve. All of these can fluctuate, and have different demands for vacuum that may cause fluctuations and variations in the system (downstream of the fitting in the manifold) that don't correspond directly to actual manifold conditions.

The FPR and MAP need a manifold source that is more stable, and indicative of actual manifold pressure at all times.

That's probably why they're plumbed to different ports. I've never really thought about this before. Thanks Don for the "food for thought".

Wouldn't the vacuum ball help minimize that? My BOV is tied into that line and I get very little change other than the outside temp variations.
 
Top