voltage question

sy112

New member
I finally noticed today that my voltage stays at 13.8 or so idling but drops to 12.9-13.0 when I go 100% TPS. Is that enough of a drop to hurt performance? Also, will it dropping below 13.xx have any effect on KR. I am having a hell of a time getting it to 0*. Have got it to where it stays below 5* except for quick spikes to 6-7* on upshifts. All of this is on 92 octane(got pump right next door, to lazy to drive anywhere else :lol: ) All the voltage numbers are straight from a TurboLink run I recorded this morning.......Ambient was 63 degrees, my IAT stayed under 90 degrees on a 0-90 mph blast........yeah 8)
 

Ian Turgeon

Cascading Inspiration
It seems the voltage reported by the computer can be an iffy measurement. I remember darron put in several computers and each reported a different voltage value.

Some can be ground/wire related as well.
 

sy112

New member
so with these numbers I should be O.K.??????? i remember reading a post from BG and he said 13.8 at WOT is real good, and good voltage is very important. Does everyone else's voltage drop so drastically at WOT? Just kind of gave me a scare this morning.
 

jwaller

Evil Genius/SyTy Guru
sy112 said:
so with these numbers I should be O.K.??????? i remember reading a post from BG and he said 13.8 at WOT is real good, and good voltage is very important. Does everyone else's voltage drop so drastically at WOT? Just kind of gave me a scare this morning.

every single truck I've seen with stock ecms does this..esp when you start goin with larger and larger injectors.....changin out the drivers helps for small injectors but the problem comes back when you go up again with injectors....

I'd say it's normal.... bc I recall comebody doing a hefty amount of research on replacing the power wires to the ecm and all kinds of stuff...but nothing helped.

what you really want to make sure of is that the battery voltage stays up on a WOT blast....
 

sy112

New member
thanks wally, i plan on installing a pte60 kit with 50#ers as soon as they get it shipped, could have made my own downpipe by now :x I should expect even more of a drop with the 50#ers? I do have the Ultimate and plan on putting 50# chip in, if that makes a difference.
 

jwaller

Evil Genius/SyTy Guru
my suggestion is to check your actual voltage at saay the cig lighter with A VOM. if your actual voltage goes down then address that but I dont bother with what dm says it seems that their isnt anything that can be done about it. other than goin to FAST or DFI.
 
Top