Was wondering

Turboz

NASTE
Could somone take a look at a DM file for me. Then maybe explain somethings to me. If someone has the time.

Thanks in advance

Jay
 

dgoodhue

BuSTeD 4.3
Drivng around it mostly looks fine, you only went WOT for a few sec in 3rd, Knock retard was only a few degrees (hit a peak of 13.7psi). The couple of part throtle boost runs had KR of 4 degrees.
 

Junior1

NASTE Member
dave could you take a look at one I did last month? Let me know I'll email it to ya...

Thanks
 

dgoodhue

BuSTeD 4.3
OK I didn't have much time lasrt night to look at your File Jay (or explain what to look for)

First I look for anything out of the ordinary when driving around under part throttle.

Your engine temperature looks fine @ (75C) 165, but your IAT are hot I saw 150F (64C) which way to hot just just driving around (150F is what mine hit a WOT at the end of the 1/4 mile.)

Your o2mv will be all over the place and should be, the important thing is imoving and the xcnts continously increment until 255 then it will start flip back to 0 and increment again.

Something funny happen to the data after you went WOT from ~45-60 mph its looks like your injector pulse width went to zero.


AT WOT I like to look at RPM (for shift points), Boost (and boost control which is a roller coster with a stock wastegate), Knock (spark) Retard, Battery Volts (should be atleast high 12V or higher) IAT, O2 mV (may drop intially at first WOT, but should be up over 900mV after a sec or so)
 

Junior1

NASTE Member
Dave,
Sent it to ya twice, once to email in sig and once to the one posted up above wasn't sure which one. Let me know how you make out.


Thanks
 

Turboz

NASTE
I noticed the injector pulse also. Think it is soemthing to worry about? If the weather is better tomorrow i will do a couple of other runs and compare them. I thought my intake temps were high, I know my intercooler pump is good already fixed it, also did the heater hose mod. The only thing I can think of is that the chip I have dosen't put the pump on constantly and I had shut my switch off the other day when I was working on the truck and I had the key on. If I don't get any before friday I can do some at the track. Thanks Dave.


Jay
 

dgoodhue

BuSTeD 4.3
Turboz said:
I noticed the injector pulse also. Think it is soemthing to worry about?

Nevermind its fine, I looked over, my Daicom stuff and it does the same thin (same with Juniors truck) I usually never look at the injector pulse width anyways.

If the weather is better tomorrow i will do a couple of other runs and compare them. I thought my intake temps were high, I know my intercooler pump is good already fixed it, also did the heater hose mod. The only thing I can think of is that the chip I have dosen't put the pump on constantly and I had shut my switch off the other day when I was working on the truck and I had the key on. If I don't get any before friday I can do some at the track.

It would be helpful to longer WOT runs, like 1 and 2nd gear or on the highway, 3rd gear, those will show up the Knock counts and knock retard.
 

dgoodhue

BuSTeD 4.3
Junior1 said:
Dave,
Sent it to ya twice, once to email in sig and once to the one posted up above wasn't sure which one. Let me know how you make out.

It appear as tyhough you have the stock chip with the IC not hardwired to be on, (hence the 195 coolant and 150-160 IAC temps) Otherise your truck looks great in your WOT 0-60 run, you have no Knock Retard what so ever, which is very rare on a stock syty, on most truck a couple of degree beteen shifts is normal.
 

Junior1

NASTE Member
Thanks Dave. I wanted a second opinion on the KR. I didn't see any on the run and just wanted to make sure I was reading it right. Your correct on the chip too, I didn't hotwire the pump because I plan on putting in an ultimate chip as soon as I get the racetronix fp setup and an afpr put in. Since the ultimate does it, I'd rather not hotwire it.
 
Top