WB not reading right?

TYTILIDIE

METH HEAD
It seems like every time I use an LC1 with the DB Gauge, I have issues. I am trying to do some tuning but it seems like the reading isn't right. I am trying to tune wot boost in the 11.5 area and anything over 10afr knocks like a bitch. So in short, I have to run in the 9's to curb KR. Makes me think that the calibration or programming for the LC1 is off. Thing is I programmed it and calibrated it to the T. Any suggestions?

Forgot to add. One of the things that makes me think something is up here is that before I started tuning this Ty, it rarely knocked and it was always less than 2*. Now here is where it gets interesting, when we put that truck on the dyno, we had boost fluctuating between 15 and 11psi, all the time running AFR's in the low 13's. And the truck didn't knock. So here I am in the 11's and 10's with more knock than I know what to do with. I hate to lean it out to 13's for shits and giggles just to see if it goes away and lose a motor.
 

The Bronze

New member
Re: WB not reading right?

As an option, you could get an I/M shop to sample the exhaust while you record your a/f. If their machine doesn't do a/f, I have a program that will do so if you give me O2,HC,CO2 and CO. It always works well for me, especially when you are trying to validate precut mixtures. Your exhaust has to be well sealed and THEIR o2 sensor has to be calibrated. That should be almost a given as they usually get a 72 hour check.
 
Top