Weird Code 43

aasltmike

Active member
Was working on the Ty earlier tonight putting some heat shielding on the battery and starter cables. When I went to connect the positive battery cable, it sparked but no power. Long story short, I had the heat shielding ending too close to the cable ends and it caused the short when I connected the battery cable. Fixed it and now the truck starts up and idles with no CEL. When I put the truck in gear, the CEL comes on and when I put it back in park, the CEL goes off. Pulling the code with the paper clip says Code 43, but eveything I searched on the forum so far comes up as knock sensor. Anyone have any ideas why the CEL is off in PARK and comes on in gear? Just trying to get some ideas of where to start when I get the time in the next couple of days to dig into it. TIA.
 

Rob2000gt

Donating Member
make sure your shield is not touching anything when in gear. engine does move a small amount when you put it in gear check drive and reverse. Also make sure the shield is tight and solid. Knock sensor will pick up small vibrations from anyone of these.

If everything is good you may have toasted the sensor

Knock code will set if the sensor sees knock for 5 seconds
 

aasltmike

Active member
Re: Weird Code 43

make sure your shield is not touching anything when in gear. engine does move a small amount when you put it in gear check drive and reverse. Also make sure the shield is tight and solid. Knock sensor will pick up small vibrations from anyone of these.

If everything is good you may have toasted the sensor

Knock code will set if the sensor sees knock for 5 seconds

OK, thanks for the info. I got a sensor on order in the event that I did fry the sensor. I got the correct part number on the site here. :tup:
 
Last edited:

aasltmike

Active member
Re: Weird Code 43

No more Code 43! Once I got in there and could actually see things, it looked like there was some exposed wire on the lead to the knock sensor. I'm guessing this is probably what caused my CEL to trip, but I replaced the sensor anyway.
 
Top