WG sel duty cycle/frequency??

myclone

Donating Member
Got a little circuit Im tinkering with to poss make a boost control for myclone and have a few questions for someone in the know on the WG selonoid..

What is the frequency that the ECM provides for the WG selonoid?

What is the duty cycle in miliseconds/microseconds at ~50% duty cycle?

How bout the same for ~25% and ~75% duty cycle?

Im assuming the WG sel is 12v. Correct? Or is it 5v?

Ive got the ckt built but need to set a refernece voltage and dont know where to start as I have never actually measured any of the above when myclone was stock.

TIA for any info.
 

smeagol

Active member
I believe the EVRV (EGR controls) are sent a 32hz signal from the ECM, I'm guessing the WG solenoid is the same. That's about all I can offer...
 
Top