what to do now

I have been having kr problems so I have done the following things.
new plugs(ur6ix gaped to .032)
new cap & rotor (conrad)
plugwires(taylors spiro pros)
o2 sensor
map sensor
tps
new pcv with the E on the bottom
knock sensor(relocated to the hole in front by the thermostat)(torqued to 14ftlbs)
iat sensor
my ia temps are in the 60-70 o2 volts 920-950
fp raises with the boost I am only running 14-15 psi
Iam still getting kr . Somtimes it is 2-3deg and sometimes it is 7-10deg I have checked to see if anything is rubbing nothing there.
What have I missed?The kr didnt change when I moved the knock sensor. and if I run 100 octane the knock goes down but not away.


Somebody please HELP
Thanks mav
 

smeagol

Active member
fuel filter
check timing, try retarding timing
top engine cleaner
take off intake and degrease
check egr valve

have you tried out the stock chip?
have you checked to make sure nothing is loose?
have you checked your rocker adjustment?

are you certain you are at only 14-15psi?
 
fuel filter-new

timing-0 deg with the tan wire disconected

top engine cleaner-done it two weeks ago

intake-did it two weeks ago

egr-deleeted

stock chip-I get about 2-3 deg tipin knock then it goes up just like the pitbull

loose-no I checked and every nut bolt and screw was tight

rocker adjustement-have not checked will check but the are not noisey

14-15psi-checked with boost gauge and dm with 2 different map sensors all read within 1-1.5 psi of eachother

anything else?or is my truck just a pos.
 

Daron

Active member
Some of the cheapie ignition modules can cause probs.

A weak coil could be an issue.

Try a closing the gap to .030, see what effect that has.
 
Top