Where to put Autometer elec oil sending unit

bender

Member
I got a new oil pressure gauge, but dont know the best place to put the sending unit. I dont have a factory filter relocator anymore, so I cant put it there, is there any other ports I can tap into? I would also like to avoid having to swap it into the factory spot buried under everything. Anybody have any suggestions.
 
Re: Where to put Autometer elec oil sending unit

I ran a brass nipple and T-fitting from the turbo oil feed port. There was just enough slack left in the factory braided hose.
 

Quickstop [UK]

Combating adversyty.
Re: Where to put Autometer elec oil sending unit

Mine comes off a port in the block I think where the oil feed for the turbo is, the hardline attachment on the dvr side. Get a T and you can put it in there as well.

I had removed the hardlines and was getting the oil feed from the extra port on the side of the stock filter, then having it go to the RPM remote filter and then on to the turbo.
 

aasltmike

Active member
Re: Where to put Autometer elec oil sending unit

I ran a brass nipple and T-fitting from the turbo oil feed port. There was just enough slack left in the factory braided hose.

Did you port it right off the factory fitting into the turbo on top? If that's the case, can I see a pic of it? I'm getting what I need together for pillar gauges and wouldn't mind doing an oil pressure gauge like that to monitor oil pressure into the turbo. Thanks.
 

nr94

swe typhoon
Re: Where to put Autometer elec oil sending unit

i did it like this .
thumb_153447-1779007.jpg
 

bender

Member
Re: Where to put Autometer elec oil sending unit

Well I came up with a free solution. I drilled and tapped my remote filter fitting. It needed ground though so I soldered one on the bottom.

IMG00026-20100222-2239.jpg

IMG00027-20100222-2240.jpg

IMG00029-20100222-2342.jpg

IMG00034-20100225-1956.jpg

IMG00036-20100225-1957.jpg
 

1madgumby

New member
Re: Where to put Autometer elec oil sending unit

That looks like A big pain in the ass. here is mine, vary simple

typhoon12.jpg


Well I came up with a free solution. I drilled and tapped my remote filter fitting. It needed ground though so I soldered one on the bottom.

IMG00026-20100222-2239.jpg

IMG00027-20100222-2240.jpg

IMG00029-20100222-2342.jpg

IMG00034-20100225-1956.jpg

IMG00036-20100225-1957.jpg
 
Top