MotorMouth
Member
Ok, this is a bit strange. I have been fortunate enough to get my Ty down to zero knock all the way throught the gears and I'm very happy. Yesterday, I bolted my enging tie down strap (tailgate strap) in on the the engine. It is bolted to the steel alternator support bracket that goes inbetween the alternator and the driver side manifold. It is bolted to the frame on the other side near the front upper control arm bolt.
After installing this I went out for some testing and HOLY COW! Where before I had zero knock (just a tap during first to second shifts) I was getting 5 to 14 degrees of knock
. I unbolted it and it went away. I spent quite a bit of time looking around for something that could have been rattling but could find nothing.
Anyone else ever had this problem?
*EDIT* I forgott to mention, I pulled the plugs out and inspecting them there did not seem to be any sighn of that sever of detonation so I am guessing that this is false knock. O2 volts were good and so on. Still not sure why it is there though.
Oh, I am still using the stock style rubber motor mounts and tranny mount.
Brian
After installing this I went out for some testing and HOLY COW! Where before I had zero knock (just a tap during first to second shifts) I was getting 5 to 14 degrees of knock
Anyone else ever had this problem?
*EDIT* I forgott to mention, I pulled the plugs out and inspecting them there did not seem to be any sighn of that sever of detonation so I am guessing that this is false knock. O2 volts were good and so on. Still not sure why it is there though.
Oh, I am still using the stock style rubber motor mounts and tranny mount.
Brian