Why we have lean cylinders

Windedv6

Ty n 10s
Re: Why we have lean cylinders

I also wonder if that recessed divider contributes to fuel puddling in those cylinders?

...Rob

Rob

I ran the single plane on my ported vortecs for several years then put on a set of brodix with the single plane intake. I both cases I get some reversion that gives some puddling in the center of the intake. I doesn't bother anything as the intake floor doesn't contribute much with regard to the air flow performance. My TT does it a lot more as I am running a cam with only .4 degrees of over-lap. The reversion is greater because the exhaust valve closed by the time the intake is open so some cylinder gases find there way back into the intake a little. NA motors with high degree of overlap and good headers with still be sucking on the cylinder when the intake valve opens thus keeping any reversion to a minimum.

John
 

turbodig

Active member
Re: Why we have lean cylinders

John's info is dead on... there's not much that you can do with the intake at larger HP/flow levels. Any issues the heads have are kinda peanuts compared to the intake.

This is also one of the big contributors to why there are so many dead motors at the low 11 sec area and beyond... if you don't watch the plugs like a hawk, you'll miss the lean cylinders.
 

turbodig

Active member
Re: Why we have lean cylinders

Rob

I ran the single plane on my ported vortecs for several years then put on a set of brodix with the single plane intake. I both cases I get some reversion that gives some puddling in the center of the intake. I doesn't bother anything as the intake floor doesn't contribute much with regard to the air flow performance. My TT does it a lot more as I am running a cam with only .4 degrees of over-lap. The reversion is greater because the exhaust valve closed by the time the intake is open so some cylinder gases find there way back into the intake a little. NA motors with high degree of overlap and good headers with still be sucking on the cylinder when the intake valve opens thus keeping any reversion to a minimum.

John

.4 degrees at .050, or @ lash?
 

Windedv6

Ty n 10s
Re: Why we have lean cylinders

.4 degrees at .050, or @ lash?


Nothing to hide with my stuff.

Here is my cam specs;

Duration@.050 234/228
Lift. .620/.573
LS 116
Valve overlap .4

installed straight up 116*

Intake rocker ratio 1.65
Exhaust raocker ratio 1.55

This is a tight lash cam. Lash set at .010 hot (6* cold)

Motor operating temp 180*


Cam Advance...
At 0* cranking compression is 160-162 psi (current setting)
At 2* advanced the cranking compression is 167-169 psi
At 4* advanced the cranking compression is 173-175 psi
At 6* advanced the cranking compression is 180-182 psi.

At 0* advance there is 13 inches of vac (current setting)
At 2* advance there is 16 inches of vac
At 4* advance there is 19 inches of vac
At 6* advanced there is 22 inches of vac

Converter Stall is 3800 rpm

Turbo are PTE 6265 billets with T3 housing
Spooling is very quick at 0* cam advance
Spooling is instanct at 6* cam advance (to quick for the present chassis setup)

My goal is to get the chassis dialed in with the radial tires and then be able to advance the cam if needed for additional low end power when the chassis can handle it.

John
 
Top