Why would it be rich

I have a pit bull chip an on dm it shows to be real rick at idle sterm goes down to 85 lterm stayes at 124 . At wot stem goes to 128 and lterm goes to 126. o2 volts are 940-960. I am running 57 psi fuel pressure with the line off. And I am running 14-15psi boost but the plugs are chalky white but no sign of detonation. why would dm show it to be rich when its not?
 

smeagol

Active member
57psi line off will definitely show up like you are reading - high short term/long term trims - that is a LOT of fuel pressure. At WOT, it's not in closed loop, trims will go to neutral (128).

You may need it up top, depending on your mods. Have you verified fuel pressure is rising up top? What are the mods..?
 
yes the fp rises 1 to 1 with boost. My mods are walbro,afpr,full tune up,pit bull chip, te44, 3 in exaust, diy alky injection
 
Ihave the fp so high to get the o2 voilts in the 930-960 range. I am running 15-16 psi . I have done a tune up like the list says to. but if I lower the fp I get kr. With the fp that high kr. seems to be under control. I tried a new o2 sensor and it read lower than the old one.
 

ed hess

race or get outta the way
fuel filter clogged or clogged injector?

just comes to mind to get injectors flowed and a new filter.

hth but wtf do i know...
ed
 
fuel filter has 500 miles on it just had the injectors cleaned and flowed. NO bend or kinks in the fuel line or the return.
 

ed hess

race or get outta the way
just for grins try it with another fp gauge.

I assume this existed before the alky? how about with the stock chip?

Also it was before the new fuel filter? before the afpr?

also take a look at the rubber portion of the fuel lines and make sure they cant move intermittantly. if the return intermittantly gets kinked and unkinked when the motor or trans moves (if it does) then fp would change. look where the lines go from the frame to the trans.
This might be off the wall but as odd as it is...

ed
 
Smeagol Yes I have 8-12 deg. kr with the fp in the normal range. Ihave a new balancer so I know it hasent slipped timing is set 1 deg retarded. I guess that matches the truck :)



Ed Tried another fp gauge and the are showing the same.
Yes the o2 and knock have always been this way.
With the stock chip I get the same kr up top but I get 3 deg tip in kr every time you hit the gas :(
Looked at the feul lines again and they wont move the trans has a energy sup. mount on it so it wont move ether


thanks for the help so far I hope we can get this sorted out :-?
 

ed hess

race or get outta the way
i recal mad mike had a kr at tip in and it turned out to be either the coil or the wires from the coil to the distributor. or possibly the wire connections to the coil.

hth

ed
 
Ed I have replaced the coil and the wires from the coil to the dis and I have replaced ign. module and it was still there this sucks
 
God I wish I lived where their was a syty guru to lay hands on this thing and make it all better :( I want to get an ultimate chip for it but cant until I get this damn thing fixed then I get to start all over :lol: I am tired of 8s in the 1\8 I want to go in the 7s
 

ed hess

race or get outta the way
other odd things ive heard onthe board.

motor mounts?
down pipe hitting frame

heat shield above dp or cat hittting the other

loose heatshields

knock sensor bad or loose

connector on knock sensor

shit this is like me when i was chasing the stall problem.

how many miles are on this motor?


ed
 
Ed Ijust tried putting a tidown strap on it and guess what Just made a pass at 14 psi and only got 1.4 deg kr with 48 psi fuel pressure. SOOOOO I guess I have a broken motor mount. Sad part is that I have a set of the J&S mounts with energy sup. mounts setting here But dont want to put them on because of peps saying they will melt.


Thanks to you and smeagl for the help.
 

ed hess

race or get outta the way
if you have headers you will be ok, if using the stock manifolds then yes you might have a problem.

Werent you chasing this problem even back when i was chasing that stall problem?

ed
 
Yes I still have the stock manifolds. And yes I have been chasing this for a while. I put a tailgate strap on it for a tidown because everybody said my chain that I was using would cause problems. So I guess I have never fixed the problem.


Once again thanks
 
Top