Wideband O2

Syclone #1188

New member
I am looking at purchasing a Moates Ostrich Emulator to tune with.

When going to a wideband system . Do you guys like to keep the factory 02 sensor with the wideband together, or remove the factory 02 sensor?
 

Davemc1963

93 Ty Owner
Re: Wideband O2

I was pondering over the same issue, except that Plx recommend that you install the WB sensor 36" down from the turbo. I have my downpipe out at the minute, so have been contemplating doing just that to help keep my sensor in good shape. That said many do what you suggest with no issues, at least not in the short/medium term anyway. Not sure if the accuracy or response time will suffer as a result longer term.
 
Re: Wideband O2

I've had a lot of issues with the integrity of the sensor and overheating in my SC 3800 Regal and that sensor is 18" downstream from the rear header. Even Innovate's heat-sink, the sensor accuracy decrease slowly overtime.

Just and FYI, Davemc1963 may have a good point, especially considering a turbo.
 

Don W.

Stab it and steer it
Re: Wideband O2

My WB is installed downstream. Close to 3'. NB still there and connected. With Eric's chip you can switch back and forth but I think he prefers to use the WB. Finding a good spot so you get to it and still R&R the thing along with protecting the wiring from heat is important. Obviously. I have mine mounted towards the front or on the outside curve of the last ell before the cat.

HTH
 

Syclone #1188

New member
Re: Wideband O2

I was pondering over the same issue, except that Plx recommend that you install the WB sensor 36" down from the turbo. I have my downpipe out at the minute, so have been contemplating doing just that to help keep my sensor in good shape. That said many do what you suggest with no issues, at least not in the short/medium term anyway. Not sure if the accuracy or response time will suffer as a result longer term.

I have the motor out now, so I guess I could weld in two wb sensors bungs. Then move it from one spot to the other and see if readings are any different.
 

Davemc1963

93 Ty Owner
Re: Wideband O2

I have the motor out now, so I guess I could weld in two wb sensors bungs. Then move it from one spot to the other and see if readings are any different.

I dont think that you would see much if any difference by swapping the same sensor from one spot to the other, because it should measure the O2 content and respond the same whichever position its in. Its just that the results may not be 'correct' if the sensor has suffered by getting too hot or is responding a little more slowly, which does happen over its life time anyway. You may possibly be able to compare one wideband sensor or its narrow band emulation over time period against the stock NB sensor or another WB sensor by checking output and correction factors with a scan tool if you have a datum point on install. Or with the Plx gauge if you have one. I'm by no means an authority on this, just trying to apply logic and follow Plx's recommendations for a trouble free reliable WB set up that keeps the A/F ratio where it is supposed to be, not where it thinks it is if the sensor becomes inaccurate.
 
Top