Will The Ultimate work with my mods??

Mkid

New member
Here's what I got..I wasn't sure if my cam would cause any problems with the Ultimate?

Stock Block... 40 over
J&E pistons
ATR crane cam...same as comp cam 2020
Stock heads..Turbo and stock cat with KB muffler
Walbro, KB AFPR, Conrad cap, KB wires

I want to get the Ultimate cuz my truck pulls like a MOFO until about 16-17lbs..then it cuts out for sec until boost goes down and kicks back in??
Thanks,
Malik
Also how much does it cost with the 3 bar??
 

Daron

Active member
The cam kinda throws a bit of a curveball into the equation, but I understand it is relatively mild. Out of any chip, the Ultimate is going to serve you the best IMHO. You happen to have a scan tool?
 

Loeryder

New member
Malik,

If it is cuttin out under boost and you're getting a CE light then that's overboost my friend.
May want to readjust that wastegate.

The Ultimate wont fix overboost, and if you're knocking on a stock chip it will get worse on the ultimate. Truck needs to be in decent tune before switching to the ult.

Hope you are using a scantool cause that motor won't last long if your knocking under 17PSI. JE pistons or not.

http://www.arautosports.com for the ult and 3 bar sensor. $300+something I recall.

I have diacomm if you'd like to do some runs.
You can always take the .gdf file and import it into datamaster for viewing in their cool graphs and stuff.

My truck has been under the cover for about a month, drove him a few weeks ago, but haven't done any wrenching since the nats.
Got a few things on the to do list that are ready to install though.

Shout back and we'll try to hook up soon.
This weekends not good with easter and all, maybe next week in the evening or next weekend if it gets nice we can meet up somewhere.
 

Mkid

New member
Thanks for reply's,

But I thought my motor has cuting out from the stock chip reading over 15lbs.

Hey Jas,

Thanks for the info!! Yeah I've got datamaster on the way along with some other stuff!! See I just got this motor a 1,000 miles ago and just being real careful about what steps I take.

My gauges where not in at the time so I couldn't read any codes so its been sitting in my garage until I can afford some stuff like datamaster etc.

Yeah I'm leaving town this Thursday and won't be back until April 16th....but mabey mid April we can hook up and do some mods or something.

Stuff on the April list:

Derale Pan, TRU-COOL trans cooler
SPA trans/engine temp gauge,
Summit trans filter, RK kustom carpet,
Alky setup with Datamaster
NITRIOUS!!!hahaha just kidding

later,
Malik
 
Top