window switch

[Slyclone]

Not sure how to title the thread.

This is for my syclone. I left the window down about 6? Mons ago . my truck was in garage and now it is sitting on my trailer I planed on moving it but haven't been able to get much done. Last weekend I tried to put my battery which I have had trickle charging. well for some reason after going through all the trouble to install the battery I was not able to get power to the ignition or windows.

I think I have a cat infiltrating Hope its just the cat. Haha but what I'm looking for is either a way to jump out the switch if there is even a way or figure out why no juice to the system. The truck has no electronics or plugs/connectors plugged in at all. Like injectors,coolant sensors, no engine sensors or connectors

Even tried 12v power pack and still nothing. Is there a way to jump out my driver window switch? I figured I would be able to get the window up but it did not work
Thanks

 

[gstacky]

Re: window switch

When you say it has no sensors plugged in, do you have the main harness unplugged at the drivers side firewall? Or the alternator connections off? Interior gets power from the alternator and through the fuse box. You can simply remove the door panel and power the window motor direct at the opening at the front of the door. Unplug the motor and power/ground to the two terminals. One way will go up, other down. Or under the dash you can unplug the window connector, red or blue, I can't remember off the top of my head, but it's labeled. Power to that and ground to the metal where the steering column attaches will give you power to the window switches.