#24's Ugly new DM run.

the baPhoon

Active member
Anyone wanna take a look at this for me? Heh, brace yourselves, it aint pretty.
Check out that knock count, Yeah, i guess it WAS knock that im hearing as it corresponds with the count in DM, either that or something is making one hell of a racket going from vac to boost.

Re ran the vac lines to clear an IAT, ESC, and EGR DTC and pulled the ECM B fuse before the short run. I didnt like the knock count and spark retard at all so i just ran it back home.


Doesnt the spark advance look a little.... odd? I mean around 30* without my foot on the throttle? really!?

Someone impart some wisdom on me if you would :)

OOPS almost forgot

HERE Is the link to the DM run..
 

WyoSyclone

Active member
Re: #24's Ugly new DM run.

Well, first off I'd say keep your foot out of it till you get some tuning done... that much knock will tear your motor apart.
You're running 20lbs boost.... get that down to 16, or so. You're also running a little lean at WOT (12)... I'd try to get that down around 11.4 or so to begin with.

edit.. your IAT's are also high.. make sure your intercooler system is working properly... that heat just adds to the problem.

What mods does the truck have?
 

the baPhoon

Active member
Re: #24's Ugly new DM run.

Stock turbo, 3 inch ATR Catback w/ the magnaflow muffler, hotwired IC, 160* thermo, PLX SM-AFR WBo2. Stock turbo @ 91 octane. Turbo wont hold boost for the life of it, itll peak and then just die out slowly, but im sure thats the uber load of KR im getting heh.
I think the IAT's are a little high cause i did the run when it was 110 outside hahaha.

Whered you see 20#'s of boost? my new boost gauge hasent shown over 12 at all and thats the max i saw in the DM run...
 

turbodig

Active member
Re: #24's Ugly new DM run.

Stock chip? You really need to get the PLX wired into the ECM to get the real benefit out of it. (and the chip patched)

You're not hitting 100% TPS at WOT.

Your intercooler needs help.

Looks like heavy-duty ignition issues.

Cheap gas?
 

the baPhoon

Active member
Re: #24's Ugly new DM run.

I remembered the last time it got filled up it was safeway 91.. Not a mistake ill make again even if i DO get 20 cents off a gallon haha.
The PLX is all wired up to the ECM but for now i had to simulate the narrowband as i dont have any of the tuning software/hardware.

As for the intercooler, this is a new issue. My engine temps have been higher then normal recently.
Im not sure what could be causing it. It normally ran around 170ish*, 180-190 on a really hot day.

Not sure what to think about the ignition either. MSD soon perhapse?

Ill go hook DM up again and back the throttle screw out untill i can hit 100%. Last time i was in the engine bay it looked a little off, too far in.
 

the baPhoon

Active member
Re: #24's Ugly new DM run.

yeah the pumps workin great, its already hot wired. I was wondering the same thing the other day after it had idled for about 2 minutes and i tried to open the upper IC cap and it blew all sorts of coolant out all over the turbo and downpipe. I can hear it running, it does sound a little distressed though.
 

turbodig

Active member
Re: #24's Ugly new DM run.

the baFoon said:
I can hear it running, it does sound a little distressed though.

Air pockets. Start squeezing hoses and work the air out.
 
Top