6psi of boost?

Throws

Active member
OK... This is (to my knowledge) a stock truck (92 Ty). No fancy schmancy tuning or anything. Got my ALDL on and recorded a boost launch... 100% TPS, 6psi or boost (14.2 targeted).

http://www.mediafire.com/?nhbqn8mg6608550

I've got a new boost valve on order, and I know the intercooler pump isn't working.

Anyone?

-P
 

WyoSyclone

Active member
Re: 6psi of boost?

If you're using DM 4.0.0, go into 'setup, 'display units' and set 'map calibration' to "2-3 bar". I'm seeing 10.7lbs of boost (223kpa).

HTH
 

Quickstop [UK]

Combating adversyty.
Re: 6psi of boost?

Do all of them. I had silicone but have gone back to rubber.

10 psi could almost be a stock boost spring (8-9 normally) - maybe your solenoid is dead?
 

Throws

Active member
Re: 6psi of boost?

HOLY FAWK!

Replaced the solenoid... it's like a totally new truck. Boost comes on and stays throughout the powerband. I tried a boost launch, chirped the tires (unable to do previously), and scared the F out of myself.

I love these trucks.

-P
 

turbodig

Active member
Re: 6psi of boost?

I'm sorta wondering why you're doing all these boost launches when the IC pump isn't working.

Lots of full boost passes with no working IC is a short path to a dead motor.
 

Throws

Active member
Re: 6psi of boost?

I guess the question I've had is why I'm not able to generate full boost. If it's the IC pump, then that's doable... but never to see the full 14~ish....?

FWIW: those 2 recordings are the only boost launches I've attempted (add one to figure out how to do).

-P
 
Top