any problems using this harmonic balancer

[tbauer03]

Pioneer DA-2621 It is apparently a stock replacement and i can get it from the local autozone easy enough for 90 bucks.
since mine has severly slipped i want to replace it but don't want to break the bank on something like a fluidamper or rattler if it is not neccessary. This is going on a pretty decent engine build hoping to see 11's out of it but is this an area where i should not skimp out on?

 

[ItsMyTy]

i would run a ati superdamper on a new engine build

but if you want a 1.5 year old, about 20k miles on it stock balancer i've got one. had it on my old engine

 

[Wes]

If you're going to be running 11s I would at least get the race version, # 872021.

http://store.summitracing.com/defau...art=PIO-872021&autoview=sku&Ntk=KeywordSearch

 

[fiveoh]

this is the one i got for my ty, it is 6.875, so you will have to cut off your stock pointer with a dremmel(or the like) and blot on a pointer for a 7 inch damper. by the way when i got the damper about 2 months ago it was only 150 bucks or so( ithink it might even have been cheaper)

but it works good and is half price of its sfi cert brother



http://store.summitracing.com/partd...art=FLU-670100&autoview=sku&Ntk=KeywordSearch


Bye the way this board is getting some bad demons :evil: :evil: :evil: :evil: , it took me three tries to post this :x

 

[tbauer03]

That race version one looks prett good for the price and it is certified my only concern is it is a smaller diameter than stock any issues there other than the timing tab being slighty off? Anyone else running that pioneer race balancer?

 

[ghettosled]

no issues since they are nuetral or internally balanced. Pioneer makes a 6 3/8 i believe. Be careful if you try and grind down the stock tab all the way, as the rivets will dissapear and you will have 2 small holes in your timing chain cover.

 

[sytyguy]

http://syty.net/phpBB2/viewtopic.php?t=41182

See my reply @ the bottom.

Hood