Big 3 conversion

95xtreme

New member
Re: Big 3 conversion

Well did this to the truck yesterday and I must say it has been one of the best modifications I have done to the truck so far. It took the strain off the electrical system, free'd up 3 volts and is not pulsing under full load.
 

95xtreme

New member
Re: Big 3 conversion

I am sure folks have done this before on here probably just a different name.

I used 4 gauge wire, but the bigger the gauge the better.

It consist of running 3 wires.

- 1 from the alternator to the battery positive of the battery post

- 1 from the negative side of the battery to a ground, frame preferred but you can go to the body.

- 1 from the engine to the frame

It basically reduces the resistance in your electrical system and is kinda must when running any form of stereo or in most cases and mine, electric fans, electric water pump and I know my shurflo pump draws alot as well and so on.

I did it for about 30 dollars at autozone using 2 battery post extenders and the wire I used pre made new battery cables since they already have the ring connectors on there, are color coded and I felt I only needed 4 gauge wire.

Like I said I was skeptical about it but am doing this to all my car regardless now.

If you need any help let me know or if you know what else it is called that would be good info
 

Flyin Ryan

hated cuz he drives fords
Re: Big 3 conversion

I did that a while back with 2 gauge wiring... also if you want to gain even more volts back run a ground from the housing of the alternator to the frame.
 

95xtreme

New member
Re: Big 3 conversion

Flyin Ryan said:
I did that a while back with 2 gauge wiring... also if you want to gain even more volts back run a ground from the housing of the alternator to the frame.

Could it be run from the housing and bracket to the frame, and save a cable?
 
Top