Bigger injectors

stariy

New member
How does it work? If I go with 36 lb for example: what other mods will I need. Or it just will make farther mods (Ultimate Chip, waistgate, header, etc.) easier? Will it make my Sy run better now, help eliminate WOT knock, etc.?
:roll: :-?

Thanks in advance
 

InvisiBill

Active member
You'll need a chip. Theoretically speaking, if you ran 50# injectors on a 25# chip, you'd be dumping in twice as much fuel as you should (since 50#ers flow twice as much as 25#ers). However, it's not a flat 25# or 50# across the whole range. At WOT, the 50#ers probably flow twice as much as 25#ers. At idle though, they might only flow 10% more (random numbers picked for comparison). The fueling values in the chip have to take into account the properties of the specific injector. You can use fuel pressure somewhat to control fueling after switching to a bigger injector, but it won't run its best unless the chip is made for the injectors.

That said, the Ultimate comes in variations for stock or 50# injectors. The 50# Ultimate is also tweaked for some other mods as well, I believe. You'll probably want to stick to stockers if you don't plan on big mods, or plan on 50#ers if you're going for a big build, unless you want to do your own tuning and chip burning (or pay someone else to).
 

stariy

New member
That is pretty much what I thought, but when I read about STG Ultimate, article say that in stock configuration injectors 100% maxed out http://www.sytyarchives.com/howto/viewarticle.php?article_name=3_bar_chip.php&dir=electronics. As we all know everything is marginal in fuel system, I just installed HP Walbro 255, but if injector maxed out truck still be suffering at WOT. This said: would it be wise to go to 30lb or 36lb and stick with existing chip (Pit bull)? Will I gain anything?
:roll:
 

Falco

Donating Member
Stariy,

I've no personal experience with them, but #32 injectors said to work well with the ultimate... However I don't know what's the gain with this.

Hopefully somebody will chime in...

Later,
 

InvisiBill

Active member
If you went to slightly larger injectors (with properties similar to stock), you'd simply be running it a little richer. If you're leaning out, you may want to do this. I'd probably wait and see how it runs on the stockers first, and upgrade only if I decided I needed it. So long as you monitor your engine properly, you shouldn't blow it up or anything, just over that small amount of fuel... People have gone pretty fast on the stock injectors...
 

smeagol

Active member
Yes, invest in a scan tool, dial in your truck. Stock injectors will run pretty fast. I wouldn't consider larger injectors until you did serious bolt ons.

In the stock chip and with the Ultimate, the stock injectors will hit 100% duty cycle, but that typically provides most trucks with enough fuel. Tuning your truck, watching a scan tool, reading plugs... that will tell you if you are getting enough fuel at WOT.
 
Top