Boost reading vs MAP vs BARO

sae

Donating Member
I'm having some issues with getting the boost numbers shown in TP5 on $59 to match up with the actual map sensor reading, I'm thinking it's something with the baro value, but I'm not sure.

For example:

MAP=169.48kPa
Boost shown=12.93psi
BARO voltage=2.48

Unless I'm looking at this wrong, that's really only 10psi or so for Chicago, no? So I'm thinking the BARO is way off.

I read on the way the BARO is read with the key turned and sometimes reads a low voltage drop, etc, but I never found a fix. I would be fine with bypassing it entirely since that would still be much more accurate than it currently is.

If I'm way off in how I'm looking at this let me know! :oops:
 
Last edited:

sae

Donating Member
Re: Boost reading vs MAP vs BARO

On some starts it's 2.48 which is correct by the manual, not sure if it matters 2bar vs 3bar though. I would have thought that the 3 bar would be 1.58v at 14.7/101.

But say 2.5v is normal, and that makes the air 14.7psi/101kpa, why would my boost shown be based off of 75ka/10.9psi air? At any spot in boost, the MAP-boost is always 75kpa/10.9psi.

In other words, I'm always 25kpa/3.6psi under my target, but it thinks I'm good
 

Aeroking

e.i.
Re: Boost reading vs MAP vs BARO

GM map sensors read on 0-5Volts. On a stock map sensor (2bar 14.7psi Max). 0volts would be Max vacuum(0kpa), and 5.0volts would be Max boost (14.7psi, 2bar, 200kpa). Of course that at ideal sea level conditions.

Psi to kpa breaks down to about 6.6kpa-to-1psi. 0boost is 100kpa, so 169kpa should be around 10.3psi boost.

Also the higher pressure map sensors all read on a 0-5volt scale. So as you switch to a 3bar, or 4bar map sensor, your voltage-to-kpa readings will be different. Because you are trying to read 0-300kpa (3bar) with the same voltage as a 0-200kpa (2bar). You lose resolution (accuracy).

So on a stock 2bar map sensor 2.50volts would be roughly 0psi/0vac. But on a 3bar map sensor 2.50 volts would be about 7.5psi of boost. So it really does matter to match your sensor with your chip.
 

sae

Donating Member
Re: Boost reading vs MAP vs BARO

Right, I have a 3 bar and $59, which is why I don't get why it shows 2.48v on the 3 for baro. The boost numbers and MAP sensor numbers don't match up, it shows 13psi at 169 kPa on the MAP sensor.
 
Top