Changing the Ultimate Display

dgoodhue

BuSTeD 4.3
It hot as hell today, so I figured I would do some work on a project that I have always wanted to do. Changing the Ultimate Display to read differently. I don't want T1-15, 16, 17 ... 24 (especially with a 9.0:1 CR motor), I want to start off with 12psi and I have thought about making a bunch programs for alky under TS-xx (street/safe, back off a couple degree of timing) or TR-xx (race). Anyways so I need to modified the display chip in the ultimate.

I pulled the chip out and I was surprise to see a PIC controller. I was expect to see a few flip flops, mux/demux for simple state machine/logic control and small EE prom to handle the LED's. I supose the PIC controller is simpler but seems like overkill, but what do I know I am a want-a-be design engineer... It probably cheaper and easier to assemble it the way it was done.

Anyways the Microchip PIC controller is PIC16F84 and has 125 page datasheet. It has a free program to downlaod MPLAB; I will have to figure out how to use it. Fortunately my PROM burner will program the PIC. I just need to figure out the PIC Logic, schematic of the LED circuitry to the PIC and what LED is used and its datasheet. I am sure I can figure out this but if anyone has any insight that would be great.
 

BigBadSmoosh

Picking fights on I-65 since 2013
Re: Changing the Ultimate Display

i've messed with pics quite a bit.. its actually very simple and can be very powerful..

read up, tons of information online about them.. and I was also surprised at how simple the ultimate's were.. just a pic and a eprom.. the pic simply changes memory locations on the eprom whenever the button is pushed, which inturn changes the actual program that runs through the ecm..

easy enough.. changing the LED output should be fairly easy, just find the mem locations associated with each settings and change the values.
 

turbodig

Active member
Re: Changing the Ultimate Display

Why not just have Todd send you a new PIC with the stuff you want programmed in?

I suspect a dump of the device will reveal some ASCII strings... that could be changed.

Dig
 

dgoodhue

BuSTeD 4.3
Re: Changing the Ultimate Display

turbodig said:
Why not just have Todd send you a new PIC with the stuff you want programmed in?

That would be the easy way wouldn't it :D I had asked him a while ago and I know he is busy. I also couldn't make any changes later.

I suspect a dump of the device will reveal some ASCII strings... that could be changed.

I was hoping I could just load the binary in and edit that, but its doesn't appear to be that easy. It's compiled and it doesn't appear to be backward compatible. The good news is that their is only about 23 lines of data in the binary due the ulitmate simplicity. Once I determine the schematics from the datasheet and decode the LED I might be able to easily pick out and change its value.
 
Top