Chip install

vinnieTy

TY # 1889
Yes I did do a search but couldn't find my answer...and sorry it's a stupid question but where the he'll is the ECM? I want to swap in my Atr chip and see how it works out. Thanks
 

WyoSyclone

Active member
Re: Chip install

It's behind the glovebox. Remove the kickpanel and underdash trim pieces. Look under the dash and you will see a brass bracket with one screw. That's the ECM bracket; remove the screw and gently pull it down.

There are detailed instructions here:

http://www.detroitturbo.com/wiki/doku.php/wideband_o2#step_3connecting_the_plx_devices_sensor_module_wires_to_the_factory_ecm

Hey, that's my Sy and my install :D .. I forgot that I had taken part in that Wiki.
 

Davemc1963

93 Ty Owner
Re: Chip install

It's behind the glovebox. Remove the kickpanel and underdash trim pieces. Look under the dash and you will see a brass bracket with one screw. That's the ECM bracket; remove the screw and gently pull it down.

There are detailed instructions here:

http://www.detroitturbo.com/wiki/doku.php/wideband_o2#step_3connecting_the_plx_devices_sensor_module_wires_to_the_factory_ecm

Being a bit of a knuckle dragger with regards to tuning, is this 'procedure' the correct one for code 28? and will it then allow you to connect the plx narrowband output to the ecm for operation whilst allowing the full wideband output to be used for data logging/tuning using the one WB O2 sensor.
 
Top