...OK...have replaced (again) the O2 sensor and put the truck back to stock (2BAR and stock chip and 42#FP). Reset the PCM and tested again.
At the moment of connection, the truck will show OPEN LOOP for about 3-5 seconds, then revert to CLOSED LOOP. I notice that through the DM display, it says that the system voltage is 12.XXVDC. I hook up my meter, and it shows 14.XXVDC. I pulled up some of my old(last year) DM runs, along with a few of the sample runs that came with the program, and in all but 2 runs (Phils runs???) it shows the PCM in CLOSED LOOP all the time. In those 2 other runs, it stays in OPEN LOOP until the water temp reaches over 70.7 degrees F, then jumps into closed loop. Is this normal? Am I misunderstanding something?
Anyways, I started looking at my normal DM run when I first got the DM and truck, and started comparing them, and it seems that I am pretty close to where I was last year. Now....the tuning questions...
1. I am going to put back the 3BAR and Ultimate. I will adjust the FP to 50-ish# with the VAC disconnected. Re-check timing. Then, using the DM's STERM and Knock display, raise FP until I get a happy medium that the PCM likes (taking out less timing).
2. After I get the above accomplished, I will install the Alky unit, reduce FP a little, and start tuning again like above.
As usual, any insight from experienced tuners is greatly appreciated.
Rds.
Alex
PS: To make matters worse, I have been invited to bring the truck to a local Chevy Dealership for a private car show they are having. You know, I may have to put a little rubber down after the event, if necessary 8)