Codes: speed sensor and ecm error???

0-60N4

Member
When I have Diacom connected and make a full throttle run, I often get two trouble codes showing up in Diacom. One says Vehicle Speed Sensor Error and the other is ECM error. It only logs this error when at full throttle. I never get a check engine light if Diacom is not connected or if it is connected. I heard this may be just a ghost error that can happen if a scanner is connected. Any ideas?
 

turbodig

Active member
Re: Codes: speed sensor and ecm error???

0-60N4 said:
When I have Diacom connected and make a full throttle run, I often get two trouble codes showing up in Diacom. One says Vehicle Speed Sensor Error and the other is ECM error. It only logs this error when at full throttle. I never get a check engine light if Diacom is not connected or if it is connected. I heard this may be just a ghost error that can happen if a scanner is connected. Any ideas?

Sounds like a data error to me.

Double check your signal ground to the cable.
Also, are you running diacom from native DOS, or from within windows?
Running within windows can often cause parallel port funkyness.

Later,

Dig
 

Ian Turgeon

Cascading Inspiration
ive seen many episodes on pop's truck/laptop where dm errors out only at wot... should be getting a data error and some noticably abscent info around those frames.
 

Loeryder

New member
I too have seen a DTC populate a cell for only one frame and then disappear with no traces.

I just attributed it to noisy electronics.
Never thought of checking the ALDL grounds, but that may help having a good ground there.

best of luck figuring it out
 
Top